Home › Specifications › Pixii PowerBase XLP
Pixii · Battery sheets
Pixii PowerBase XLP
The cheapest megawatt charger is the one you do not have to dig a new grid connection for. A PowerBase XLP holds just over 2 MWh and gives 1,000 kW back, so the site draws power slowly all day and spends it fast when a truck arrives. Pixii publishes no price, so the saving against a grid reinforcement is the number to ask your installer for.
Battery2025.7 kWh
DC charging1000 kW
30 of 44 values are filled in.
Know one we are missing, or one that is wrong? This sheet is open for anyone to correct — type into it on eTRUCKTCO.eu, press Review & send, and confirm the e-mail. It is on all three sites the moment we have checked it.
Correct or complete this sheet
General 5 / 8
| ModelProduct name as sold | PowerBase XLP 1MW/2MWh, multi-cooling, LFP | ↗ ↗ |
|---|---|---|
| What it is | Outdoor battery storage that buffers a truck charging site: it charges slowly from a small grid connection and discharges fast into the charger | ↗ ↗ |
| FormPack, module, rack, cabinet or container | Outdoor cabinet, pre-wired and factory-configured on a steel skid, lifted into place in one piece | ↗ |
| AnnouncedPixii sells the XLP as a catalogue product; the sources read do not give a launch date | not published | |
| IAA Transportation 2026Hall and stand not published. It stood at the megawatt-charging demonstration Milence ran with Daimler Truck, MAN Truck & Bus and Scania | Shown in the Milence megawatt-charging demonstration | ↗ |
| Availability in EuropeMilence already runs a comparable Pixii system at its truck charging park near Kassel | On sale; three PowerBase XLP builds are listed (fan-filter cooling, multi-cooling, cabinet only) | ↗ ↗ |
| List priceNot published | not published | |
| WarrantyNot published on the product page | not published |
Energy and power 8 / 10
| Capacity, gross126 battery units installed | 2025.7 kWh | ↗ |
|---|---|---|
| Capacity, usableAt 90 % maximum depth of discharge | 1823.1 kWh | ↗ |
| VoltageAC side: three-phase, -10/+15 %, 50 Hz. The battery string voltage is not given on the product page | 400 V | ↗ |
| Charge powerNominal continuous AC power, the same in both directions | 1000 kW | ↗ ↗ |
| Discharge powerNominal continuous AC power. electrive writes 'up to 1 MW' for the IAA demonstration | 1000 kW | ↗ ↗ |
| Charge rateThe rate Pixii's cycle figure is measured at (0.5 C at 25 ± 5 °C) | 0.5 C | ↗ |
| Charge timeNot published | not published | |
| CyclesAt 25 ± 5 °C and 0.5 C, to 70 % state of health, at 90 % depth of discharge | 7600 | ↗ |
| EfficiencyMaximum inverter efficiency. Pixii does not publish a round-trip figure for the whole system | 96.9 % | ↗ |
| Service lifeNot published; Pixii gives the cycle figure instead | not published |
Cells and build 4 / 8
| ChemistryLithium iron phosphate | LFP | ↗ ↗ |
|---|---|---|
| Cell formatPixii names the battery unit, not the cell format: LFP 314 Ah, 16S 5U | not published | |
| Cell supplierNot published | not published | |
| Architecture | 126 LFP battery units (314 Ah, 16S 5U) with PixiiBox converters, pre-wired on one steel skid | ↗ |
| Energy density, by massNot published for the complete system | not published | |
| Energy density, by volumeNot published | not published | |
| MassEquipped with batteries and PixiiBoxes | 23756 kg | ↗ |
| DimensionsHeight × width × depth | 2528 × 6334 × 2380 mm | ↗ |
Thermal and safety 4 / 6
| CoolingThis is the multi-cooling build; a fan-filter build is also sold | Dual-zone active cooling: air conditioning for the battery section, fan cooling for the power conversion | ↗ ↗ |
|---|---|---|
| Operating temperature | -20 to +45 °C | ↗ |
| Protection ratingOutdoor enclosure | IP55 | ↗ |
| StandardsPlus grid codes for the EU, the UK, Australia/New Zealand and Germany | IEC/EN 62040-1, IEC/EN 62109-1, IEC/EN 62109-2, IEC/EN 62477-1 | ↗ |
| Thermal runaway containmentNot published | not published | |
| Battery managementCommunication is encrypted and the system is described as GDPR compliant | not published |
At the depot 6 / 8
| Grid connection behind itNot published, and it is the point of the product: the site draws slowly and delivers fast | not published | |
|---|---|---|
| Peak shavingThe buffer lets a limited grid connection serve a megawatt charger | yes | ↗ |
| AC- or DC-coupledThree-phase 400 V on the grid side, with the converters inside | AC-coupled | ↗ |
| InverterMaximum efficiency 96.9 % | PixiiBox converters, built in | ↗ |
| Chargers it feedsPixii lists EV charging among the markets for the XLP family | At IAA Transportation 2026 it buffered an Alpitronic HYC1000 megawatt charger (up to 1,000 kW) in Milence's demonstration with Daimler Truck, MAN and Scania | ↗ ↗ |
| Footprint6.33 m wide, 2.38 m deep, 2.53 m high | About 15 m² of ground | ↗ |
| NoiseNot published | not published | |
| Installation | Pre-wired and factory-configured; lifted into place in one piece on its steel skid | ↗ |
Company 3 / 4
Where these figures come from
- Pixii: PowerBase XLP, 1MW/2MWh, Multi-cooling, LFP - product page with the full specification
- Pixii: PowerBase XLP product family (variants, chemistry, company details)
- electrive, 16 September 2026: Milence and Alpitronic announce megawatt charging partnership (the IAA demonstration ran on a Pixii PowerBase XLP, 1 MW / 2 MWh)
Other battery sheets
BYD Blade Battery, 651 kWh
EVE Energy Open Source Battery 4.0
BorgWarner LFP Compact Pack
IMPACT UNIVERSUS
BMZ VERSORA LMFP
CATL TECTRANS II
Shell / FAW TRUCKS immersion cooling battery
FENECON Industrial XL
Hivolt 380X
MAN Smart Charging Cube
FENECON Industrial S
Huawei FusionCharge DC storage
All 94 sheets